SKU: R1055BD
Top handle allows dedicated flow to three functions
Up to two shared functions may be actuated at once
Degree of diverter engagement allows flow rate adjustment. CALGreen compliant.
Cast brass construction
Service stops included
Primary screens at the cartridge
Temperature control with integrated three outlet diverter; factory setting at 100°F
Bottom outlet for tub filler only. A separate flow control valve and trim required for this application.
Back of valve to finished wall 3 1/2 inch min., 5 1/4 inch max.
Flow rate 6.7 GPM at 60 PSI
1/2 inch male inlets, 3 x 1/2 inch male outlets
Complete with mud guard for installation
If PEX is utilized, oversize the supply line to 3/4 inch for full flow capacity
If only two outlets are being utilized, cap is included to close dead outlet
Bottom control sets temperature
Extension kits included, may be cut to length required
Must order trim to complete
California Non-Compliant
Top handle allows dedicated flow to three functions
Up to two shared functions may be actuated at once
Degree of diverter engagement allows flow rate adjustment. CALGreen compliant.
Cast brass construction
Service stops included
Primary screens at the cartridge
Temperature control with integrated three outlet diverter; factory setting at 100°F
Bottom outlet for tub filler only. A separate flow control valve and trim required for this application.
Back of valve to finished wall 3 1/2 inch min., 5 1/4 inch max.
Flow rate 6.7 GPM at 60 PSI
1/2 inch male inlets, 3 x 1/2 inch male outlets
Complete with mud guard for installation
If PEX is utilized, oversize the supply line to 3/4 inch for full flow capacity
If only two outlets are being utilized, cap is included to close dead outlet
Bottom control sets temperature
Extension kits included, may be cut to length required
Must order trim to complete
California Non-Compliant
Limited Lifetime Warranty