SKU: R1053BD
Top handle diverts the water three ways
Degree of diverter engagement allows flow rate adjustment. CALGreen compliant.
Service stops included
Primary screens at the cartridge
Temperature control with integrated three outlet diverter; factory setting at 100ºF
Cast brass construction
Bottom outlet for tub filler only. A separate flow control valve and trim required for this application.
Back of valve to finished wall 3 1/2 inch min., 5 1/4 inch max.
Flow rate 6.7 GPM at 60 PSI
1/2 inch male inlets, 3 x 1/2 inch male outlets
Complete with mud guard for installation
If PEX is utilized, oversize the supply line to 3/4 inch for full flow capacity
If only two outlets are being utilized, cap is included to close dead outlet
Bottom control sets temperature
Extension kit included, may be cut to length required
Must order trim to complete
Shared function diverter cartridge available, order 11417
Formally the R1050BD
Top handle diverts the water three ways
Degree of diverter engagement allows flow rate adjustment. CALGreen compliant.
Service stops included
Primary screens at the cartridge
Temperature control with integrated three outlet diverter; factory setting at 100ºF
Cast brass construction
Bottom outlet for tub filler only. A separate flow control valve and trim required for this application.
Back of valve to finished wall 3 1/2 inch min., 5 1/4 inch max.
Flow rate 6.7 GPM at 60 PSI
1/2 inch male inlets, 3 x 1/2 inch male outlets
Complete with mud guard for installation
If PEX is utilized, oversize the supply line to 3/4 inch for full flow capacity
If only two outlets are being utilized, cap is included to close dead outlet
Bottom control sets temperature
Extension kit included, may be cut to length required
Must order trim to complete
Shared function diverter cartridge available, order 11417
Formally the R1050BD